Lee Loader

Hello from a newbie (to reloading - a shooter for 60 years or so).

I shot my first 30 cartridges yesterday and wanted to post the results for input.

I'm also looking for suggestions for non-obvious sources for data on cast bullet reloading the 9mm.

I used my new Lee Pro 4000.

125g cast bullets from HSM over WinClean 244 power in new Sig brass using Federal small pistol primers.

All loads at 1.125"+/- COL.

First 10 baby bear loads: 3.6g+/- averaged 1005fps : deviation 21.9
Second 10 mama bear loads: 3.8g+/- averaged 1050fps : deviation 13.4
Third 10 papa bear loads: 4.1g+/- averaged 1129 : deviation 25.4

Third load was most accurate. Here's first 5 at 15 yards.
I was given some Dupont PB and IRM PB powder (I've read the formula changed after IRM took over the DuPont product.

If anyone has cast bullet load data/experience with either for 124 or 145 coated cast bullets or my original HSM 125g cast, I'd love to hear it.

Thanks for welcoming me to your community!

If it leads at the breach it's too small .
If it leads at the muzzle it's lube .
Load to magazine length and adjust to feed and battery freely .
Jacketed data has been successfully used a lot for cast and more so with PC