PRO 1000 - Primer "Sensor" Clip - a question!
Posted: 29 Feb 2024 07:38
Good day to you all.
Is it possible that some of you good folks on here could explain how the "Sensor Clip" is supposed to operate?
As I see it, if there's a case in the system the clip is held away from the boss on the stem of the little primer "ram" (pin). With no case in the system the clip should bear against the boss on the stem of the primer pin and thus prevent it from falling down and thereby preventing another primer from loading onto the pin.
The thing has never worked well for me, and now it does nothing at all. Nothing is bent , twisted or otherwise out of place as far as I can tell. I'm beginning to wonder whether the slot cut in the underside of the shell plate (and into which the "Sensor Clip" fits) has been cut deep enough to enable the clip to put sufficient pressure on the primer pin stem?
Or could it be that the primer feed tray is worn? CCI primers exclusively.
Any thoughts or advice gratefully received, thanks!
Is it possible that some of you good folks on here could explain how the "Sensor Clip" is supposed to operate?
As I see it, if there's a case in the system the clip is held away from the boss on the stem of the little primer "ram" (pin). With no case in the system the clip should bear against the boss on the stem of the primer pin and thus prevent it from falling down and thereby preventing another primer from loading onto the pin.
The thing has never worked well for me, and now it does nothing at all. Nothing is bent , twisted or otherwise out of place as far as I can tell. I'm beginning to wonder whether the slot cut in the underside of the shell plate (and into which the "Sensor Clip" fits) has been cut deep enough to enable the clip to put sufficient pressure on the primer pin stem?
Or could it be that the primer feed tray is worn? CCI primers exclusively.
Any thoughts or advice gratefully received, thanks!