My Henry Big Boy Steel shows a .431 groove diameter. Very few of the on-line casters size different than .430. I found one, GT Bullets, that will size .432. In theory that should work. Any body with experience with GT I'd like to hear.
I tried Penn and discovered that Bob passed and the company is currently shut down
Make smoke,
44 Mag rifle bullets
-
- Supporter
- Posts: 888
- Joined: 06 Mar 2016 16:09
- My Press Choice: Hand Press
- Location: SW Ohio
- Has thanked: 156 times
- Been thanked: 240 times
44 Mag rifle bullets
Curt.......makin' smoke and raising my carbon foot print one cartridge at a time
- mr surveyor
- Founding Member
- Posts: 650
- Joined: 30 Jun 2013 09:30
- My Press Choice: Hand Press
- Location: NE Texas
- Has thanked: 386 times
- Been thanked: 231 times
Re: 44 Mag rifle bullets
I didn't mention on the other site that the GT 44 mag bullet I favor is their LHP G/C 240 grain, sized .430. It works well in my R92.
One other thing I didn't mention is that I always tumble lube all the cast bullets I use, regardless of what lube comes on them from the maker. Just my usual mix of LLA and mineral spirits is used in an old screw top aluminum Coors can get used, then the wet bullets are stood up at attention on waxed paper to dry without rubbing shoulders. Over a few days of bits of spare time I'll tumble lube 500-1000 bullets to put up in plastic peanut cans for storage and use.
A couple of years ago the owner of LeadHead bullets died and I lost my then-favorite LeadHead 265 grain gas checked 44 mag bullet. Those were fantastic in my R92 and I couldn't find another commercial "micro-brewer" that made anything to compare to the style .... the GT bullet, even though lighter and hollow point style, turned out to give the same on paper performance - and a bit less expensive.
jd
One other thing I didn't mention is that I always tumble lube all the cast bullets I use, regardless of what lube comes on them from the maker. Just my usual mix of LLA and mineral spirits is used in an old screw top aluminum Coors can get used, then the wet bullets are stood up at attention on waxed paper to dry without rubbing shoulders. Over a few days of bits of spare time I'll tumble lube 500-1000 bullets to put up in plastic peanut cans for storage and use.
A couple of years ago the owner of LeadHead bullets died and I lost my then-favorite LeadHead 265 grain gas checked 44 mag bullet. Those were fantastic in my R92 and I couldn't find another commercial "micro-brewer" that made anything to compare to the style .... the GT bullet, even though lighter and hollow point style, turned out to give the same on paper performance - and a bit less expensive.
jd
--------------------------------------------------------------------------------------
There's just some things best left unsaid on the internetsuperhighway.
There's just some things best left unsaid on the internetsuperhighway.