New Loading Bench
Posted: 28 Feb 2022 21:30
Let me preface this with the fact that I do professional photography as a side job. File sizes need to have as much information as possible. It's beyond me to downsize even cell phone pix to post to the web . More information is better, as my mentor says
Having said that, I can't seem to downsize my cell phone pix (the bane of a wedding photographer )
Here's my question:
Just built a new loading bench. Length is 8 ft (96 inches. depth of 24 inches. Shelf below is 16 inches deep to allow foot room when standing. Height is 42 inches. There are three 2x4's at the front edge in a torsion beam type configuration for press stability. The left end and the entire back of the bench are secured to the studs, so stability of the bench is there. The lower shelf is 16 inches deep to allow foot room when standing and the potential use of a stool for the occasional extended periods of loading. The shelves above and to the right are 11 inches deep.
My question/concern is this; How much space to allow between presses? My intent is to put the Lee LM to the left side of the bench with the Lee Value Turret Press (LVT) to it's right. The LM will eventually have a bullet feeder mounted. I'm hoping to have some type of O-frame press mounted to the right of the LVT.
I'd like to keep the right end of the bench open enough to maintain an area for cleaning of firearms.
When I can figure out (OKAY, bring myself) to downsizing the photo to acceptable size, I'll post a photo of the bench.
Having said that, I can't seem to downsize my cell phone pix (the bane of a wedding photographer )
Here's my question:
Just built a new loading bench. Length is 8 ft (96 inches. depth of 24 inches. Shelf below is 16 inches deep to allow foot room when standing. Height is 42 inches. There are three 2x4's at the front edge in a torsion beam type configuration for press stability. The left end and the entire back of the bench are secured to the studs, so stability of the bench is there. The lower shelf is 16 inches deep to allow foot room when standing and the potential use of a stool for the occasional extended periods of loading. The shelves above and to the right are 11 inches deep.
My question/concern is this; How much space to allow between presses? My intent is to put the Lee LM to the left side of the bench with the Lee Value Turret Press (LVT) to it's right. The LM will eventually have a bullet feeder mounted. I'm hoping to have some type of O-frame press mounted to the right of the LVT.
I'd like to keep the right end of the bench open enough to maintain an area for cleaning of firearms.
When I can figure out (OKAY, bring myself) to downsizing the photo to acceptable size, I'll post a photo of the bench.