Need a specialty die from a standard
Posted: 23 Feb 2021 12:27
So my train wreck goes like this .
6.5 Japanese nominal .257×.268 barrel that will swallow a .280 dia bullet and chamber freely with a .275 seated . At the end of it all I need to only size the necks down to .270 or so vs .261 that the standard dies do .
Failure ..... There's no 27-08 well there is but I don't need a form/trim die or a $120 2 die set . The Japanese is bigger than the 7-30 in dia . Hornady offers a bushing neck die for 6.5 CM , 260 , and 7-08 ..... But then I have to buy 3-4 bushings , thankfully those are half of of Redding . That brings me to the Lee collet sizers and turning a custom pin . Those are at the moment available for 7-08 and one or the other of the 6.5s .
The question is now is are the 6.5 collets big enough to get a .298 neck in and size to .294 OD or will the 7mm go that far down ?
If someone has a 7-08 standard sizer and could run 1x or annealed case in it sans the expander that would help for guidance . At a $1 a case in good times for the Japanese brass I have to make them last .
6.5 Japanese nominal .257×.268 barrel that will swallow a .280 dia bullet and chamber freely with a .275 seated . At the end of it all I need to only size the necks down to .270 or so vs .261 that the standard dies do .
Failure ..... There's no 27-08 well there is but I don't need a form/trim die or a $120 2 die set . The Japanese is bigger than the 7-30 in dia . Hornady offers a bushing neck die for 6.5 CM , 260 , and 7-08 ..... But then I have to buy 3-4 bushings , thankfully those are half of of Redding . That brings me to the Lee collet sizers and turning a custom pin . Those are at the moment available for 7-08 and one or the other of the 6.5s .
The question is now is are the 6.5 collets big enough to get a .298 neck in and size to .294 OD or will the 7mm go that far down ?
If someone has a 7-08 standard sizer and could run 1x or annealed case in it sans the expander that would help for guidance . At a $1 a case in good times for the Japanese brass I have to make them last .