load Master Spent Primer Cover
-
- Posts: 7
- Joined: 30 Oct 2019 14:40
- My Press Choice: Turret
- Location: KY
- Been thanked: 3 times
load Master Spent Primer Cover
I need to remove the door that you open on the bottom of the Load Master ram to remove spent primers. I think I may have bent it by running the ram up with the door open so I need to replace it. Is it just a matter of removing the bolt on the bottom to remove the carrier and then take it all the way out? I'd like to know for sure before I start fiddling around with it.
- Ranch Dog
- Site Admin
- Posts: 6458
- Joined: 22 Jun 2013 17:16
- My Press Choice: Progressive
- Location: Inez, TX
- Has thanked: 1617 times
- Been thanked: 2851 times
Re: load Master Spent Primer Cover
From what I recall, yes, pull the draw bolt. Of course, that sets everything in motion to get it back together; indexing and tightening to the required torque.cheech wrote:I need to remove the door that you open on the bottom of the Load Master ram to remove spent primers. I think I may have bent it by running the ram up with the door open so I need to replace it. Is it just a matter of removing the bolt on the bottom to remove the carrier and then take it all the way out? I'd like to know for sure before I start fiddling around with it.
Michael
-
- Supporter
- Posts: 1003
- Joined: 09 Nov 2015 06:35
- My Press Choice: Single Stage
- Location: Washington State
- Has thanked: 38 times
- Been thanked: 274 times
Re: load Master Spent Primer Cover
It's been a looong time ago but I seem to remember there is a part you have to remove in the ram bottom to accomplish that. I could be wrong here but I also think I pulled the ram off (easy to do) to do that. Just be prepared for that possibility.