Page 2 of 2
Re: Loadmaster Primer Anvil spring
Posted: 15 Sep 2020 00:41
by MikelLikesIt
I saw one guy say this is how you verify your spring is located crrectly. Lower the lever, raising the primer pin. Tale a screwdriver and push the pin sideways and hold it. Drop the lever. Removethe screwdriver. If the pin drops its located. If the pin doesnt, it isnt.
Re: Loadmaster Primer Anvil spring
Posted: 15 Sep 2020 05:20
by Ranch Dog
I will give it a try. Sounds reasonable.
Re: Loadmaster Primer Anvil spring
Posted: 18 Apr 2024 19:07
by tunaman
According to Mike at Mikes Reloading bench the spring is actually too long and may cause issues. You can put a small spring right on the primer post instead of the lee spring or cut it.