Home for the "Low Life Lee Lovers! The Forum for the Lee Precision Enthusiast! This site is not associated with Lee Precision nor is Lee Precision responsible for this site's content. https://www.lee-loader.com/
Ranch Dog wrote:My APP has been shipped from Titan along with all the tools!
Cool, mine is on back order at Titan also, maybe some day soon.
Make smoke,
Re: I'm All In ~ App Press Deluxe
Posted: 10 Feb 2020 21:40
by Ranch Dog
It arrived...
Re: I'm All In ~ App Press Deluxe
Posted: 14 Feb 2020 06:20
by Ranch Dog
The APP is on the bench...
Elevator bolts used to attach APP to bench plate cannot exceed 1" in length.
Slow going right now, a lot of chores and other work, plus I'm getting together all the unused stuff in the reloading room that is going to hit the road.
Re: I'm All In ~ App Press Deluxe
Posted: 14 Feb 2020 07:56
by Ohio3Wheels
According to USPS tracking mine is due here today.
Make smoke,
Re: I'm All In ~ App Press Deluxe
Posted: 14 Feb 2020 09:11
by farmerjim
Mine will be here tomorrow.
Feb 15 update.
It's Here.
Re: I'm All In ~ App Press Deluxe
Posted: 14 Feb 2020 22:23
by Tonerboy1
Ordered mine Jan 28,order says BO until March 29, w/ only 3 units expected then. Wont be surprised if it gets extended beyond that.
Re: I'm All In ~ App Press Deluxe
Posted: 15 Feb 2020 05:45
by Ranch Dog
Tonerboy1 wrote:Ordered mine Jan 28,order says BO until March 29, w/ only 3 units expected then. Wont be surprised if it gets extended beyond that.
Who did you order it from? Titan seems to be getting them by the pallet loads.
Re: I'm All In ~ App Press Deluxe
Posted: 15 Feb 2020 11:27
by horseman
Is the bolt pattern the same as the classic presses? The base does look smaller.
Re: I'm All In ~ App Press Deluxe
Posted: 15 Feb 2020 15:30
by Ranch Dog
horseman wrote:Is the bolt pattern the same as the classic presses? The base does look smaller.
Yep, smaller but uses a pattern on bench plate.
Decapping...
[BBvideo 560,340][/BBvideo]
I want three more, each setup for a different function!
Re: I'm All In ~ App Press Deluxe
Posted: 15 Feb 2020 15:59
by horseman
Nice video RD. It appears there is but one tube on the case feeder. Was/am I correct that the multi-tube unit will work on this press as well? I thought that's what I read on one of the sellers websites.