270 won't fit into sizing die
Posted: 31 Jan 2019 16:54
I just got a 270 winchester pacesetter die set. The case won't feed all the way into the full length sizing/decaping die. Is it possible the die is mis-labeled?
Home for the "Low Life Lee Lovers! The Forum for the Lee Precision Enthusiast! This site is not associated with Lee Precision nor is Lee Precision responsible for this site's content.
https://www.lee-loader.com/
To figure out if it is a die problem or a problem related to the Ez-X-Expander, remove the pin completely and try sizing a case. The nut that secures the expander is called a "clamp". Might be a silly question, but are you lubing the cases?bluetick wrote:I just got a 270 winchester pacesetter die set. The case won't feed all the way into the full length sizing/decaping die. Is it possible the die is mis-labeled?
Was going to ask the "Lube" question also.Ranch Dog wrote:To figure out if it is a die problem or a problem related to the Ez-X-Expander, remove the pin completely and try sizing a case. The nut that secures the expander is called a "clamp". Might be a silly question, but are you lubing the cases?bluetick wrote:I just got a 270 winchester pacesetter die set. The case won't feed all the way into the full length sizing/decaping die. Is it possible the die is mis-labeled?
With what?bluetick wrote:Lubed ouside and inside the neck.