Got me again..... Why do I bother to go there?
Just got the following
1 - Lee Classic 4 Hole Turret
1 - in-line fabrication quick change plate (holds 2 bins and 3 shell holders)
1 - in-line fabrication reverse indexing rod with ejector arm, and ramp
6 - Lee turrets
3- Lee auto disk powder measures with disks
3 - Lee Auto Drum measures
3- Powder Measure risers
2 - Lee auto disk micrometers
Large and Small primer holders
I needed this like I needed another hole in my head, but for $175 + shipping, it seemed like a deal.
I'll need to pick up a safety prime set
Dang it Fleabay !!!
- Ranch Dog
- Site Admin
- Posts: 6458
- Joined: 22 Jun 2013 17:16
- My Press Choice: Progressive
- Location: Inez, TX
- Has thanked: 1617 times
- Been thanked: 2851 times
- Old Scribe
- Supporter
- Posts: 369
- Joined: 02 May 2015 09:13
- My Press Choice: Turret
- Location: State of Jefferson
- Has thanked: 461 times
- Been thanked: 120 times
Re: Dang it Fleabay !!!
Looks like you went over the edge!
"Well here's another nice mess you've gotten me into." Oliver Hardy
- Et2ss
- Moderator & Supporter
- Posts: 143
- Joined: 18 Nov 2018 19:56
- My Press Choice: Progressive
- Location: Far too close to the edge
- Has thanked: 4 times
- Been thanked: 68 times
Re: Dang it Fleabay !!!
Well I went and mounted it to the bench last night. I must say I am impressed with the quality of it. From seeing the videos on these, they look cheap as the turret moves around/up & down while reloading.
I threw in the indexing rod and case flipper, and figured, I'm not going to use the flipper, not until I get used to the press first. Probably even skip the indexing rod to start.
I do like the idea of setting up my round cased dies into the turrets and storing the whole turret in the round cases
I threw in the indexing rod and case flipper, and figured, I'm not going to use the flipper, not until I get used to the press first. Probably even skip the indexing rod to start.
I do like the idea of setting up my round cased dies into the turrets and storing the whole turret in the round cases