Lee Loader

Got me again..... Why do I bother to go there?

Just got the following

1 - Lee Classic 4 Hole Turret

1 - in-line fabrication quick change plate (holds 2 bins and 3 shell holders)

1 - in-line fabrication reverse indexing rod with ejector arm, and ramp

6 - Lee turrets

3- Lee auto disk powder measures with disks

3 - Lee Auto Drum measures

3- Powder Measure risers

2 - Lee auto disk micrometers

Large and Small primer holders

I needed this like I needed another hole in my head, but for $175 + shipping, it seemed like a deal.

I'll need to pick up a safety prime set

Yeah, you are hooked.

Looks like you went over the edge!

Always good to have extras.

Well I went and mounted it to the bench last night. I must say I am impressed with the quality of it. From seeing the videos on these, they look cheap as the turret moves around/up & down while reloading.

I threw in the indexing rod and case flipper, and figured, I'm not going to use the flipper, not until I get used to the press first. Probably even skip the indexing rod to start.

I do like the idea of setting up my round cased dies into the turrets and storing the whole turret in the round cases