Page 1 of 1
9mm ammoload brass
Posted: 07 Oct 2013 16:13
by f100cleveland
Sorting through the 9mm brass I bought and came across 10 9mm brass with ammoload on them. Inside they have a ridge that looks like a bullet stop or reinforced base for hot load. I don't have enough to mess with trying to figure out a load. I'm sure it would be different with the smaller area to hold powder and pressures might spike. Anybody ever seen them or loaded them?
Re: 9mm ammoload brass
Posted: 07 Oct 2013 20:41
by Ranch Dog
f100cleveland wrote:Sorting through the 9mm brass I bought and came across 10 9mm brass with ammoload on them. Inside they have a ridge that looks like a bullet stop or reinforced base for hot load. I don't have enough to mess with trying to figure out a load. I'm sure it would be different with the smaller area to hold powder and pressures might spike. Anybody ever seen them or loaded them?
How about a picture
Re: 9mm ammoload brass
Posted: 08 Oct 2013 20:57
by f100cleveland
I'm not good at getting pic's off my phone but I googled ammoload and there was some pic's on my search. Odd 9mm brass - Marlin Firearms Forum
Re: 9mm ammoload brass
Posted: 09 Oct 2013 16:56
by Maximumbob54
Sounds like it's just a cannelure in brass case. They help prevent bullet set back into the case. They don't do anything to your reloading them and over multiple reloads they will iron out. If that's what you are describing of course.