The new Lee two cavity bullet molds
-
Maximumbob54
- Founding Member
- Posts: 736
- Joined: 30 Jun 2013 09:30
- My Press Choice: Turret
- Location: Kingsland, GA
- Has thanked: 51 times
- Been thanked: 222 times
Re: The new Lee two cavity bullet molds
Lee drives me nuts only offering some of their designs in the two cavity mold. I HATE THAT!!!! Lee, if you are out there please offer all your molds as six cavity!!!!
-
thecyberguy
- Posts: 8
- Joined: 23 Dec 2013 15:07
- My Press Choice: Turret
- Location: Western Maine
- Has thanked: 1 time
- Been thanked: 3 times
Re: The new Lee two cavity bullet molds
I have one of the new designs , the 309 150.
The only issue I have had is the narrow base wedges in my mold guide on my OLD Lyman moldmaster XX pot.
The base is just a tad smaller then the slot in the mold rest and if i cock it just a bit it wedges.... :-(
TCG
The only issue I have had is the narrow base wedges in my mold guide on my OLD Lyman moldmaster XX pot.
The base is just a tad smaller then the slot in the mold rest and if i cock it just a bit it wedges.... :-(
TCG
-
beekeeper
Re: The new Lee two cavity bullet molds
Was just about to ask about the new molds until I read this post.
Sure am glad I bought just about 1 of every mold Lee sold before the new ones came out..
Keep checking their catalog and so far haven't found a new one I need.
beekeeper
Sure am glad I bought just about 1 of every mold Lee sold before the new ones came out..
Keep checking their catalog and so far haven't found a new one I need.
beekeeper