Page 1 of 1
Xd 9. And Lee 120tc oal question. Also 125-2r round nose
Posted: 21 Nov 2015 17:55
by saxmann10
Lee 120tc bullet in a xd9.having problem setting oal. Set at 1.095 passes the plunk test on a dummy round. But new to reloading 9mm and worried about pressure.lyman has sim bullet at 1.110. I also coasted some Lee 125-2r round nose to set up next. Any help appreciated .
Re: Xd 9. And Lee 120tc oal question. Also 125-2r round nose
Posted: 21 Nov 2015 19:50
by Steve
Are you below the max load listed in the load manual?
Re: Xd 9. And Lee 120tc oal question. Also 125-2r round nose
Posted: 22 Nov 2015 08:17
by saxmann10
Just working some dummy rounds. But will start at low end. I have titegroup ,universal ,wsf,700x and a lot of csb-1(using universal data)been happy with the csb1 universal is kind of dirty burning .
On the 120tc---- 1.107 oal hits the rifling in barrel, 1.095 . Passes the plunk test, but just covers the top of lube groove. Could go deeper to just below the drive band but concerned about pressure problems.
I have no problems with 45acp and developed a accurate round for 200swc and 230tc