Any chance of pics of your loads?
I just made a small test batch of mine this afternoon:
They are 4.5gr of Trail Boss for some powder puff starter loads. I'm trying to figure how much crimp may end up being needed and how much recoil I will eventually be in for with these flying dinner plates.
Off on a new adventure
-
- Founding Member
- Posts: 736
- Joined: 30 Jun 2013 09:30
- My Press Choice: Turret
- Location: Kingsland, GA
- Has thanked: 51 times
- Been thanked: 222 times
-
- Posts: 36
- Joined: 30 Jun 2013 09:50
- My Press Choice: Turret
- Location: SW Ohio
- Has thanked: 4 times
- Been thanked: 7 times
Re: Off on a new adventure
I didn't make back into the lab, I ended up cooking the last bone in loin roast off of the hog I bought last November. Mboy oh boy that was some good eatin.
I'm planning on loading first thing tomorrow, so I should have some pics up of my new artillery shells. That mold sucks down the lead!
I'm going to start with alliant 2400, but your trail boss load sounds interesting too. In either case, I'm not looking for earth shattering speed. That's why I'm thawing a block of lead downstream. ,
I'm planning on loading first thing tomorrow, so I should have some pics up of my new artillery shells. That mold sucks down the lead!
I'm going to start with alliant 2400, but your trail boss load sounds interesting too. In either case, I'm not looking for earth shattering speed. That's why I'm thawing a block of lead downstream. ,