One of the problems with using the Collator to fill the case feeder tubes is that with the 32 Auto, 380 Auto, and 9mm Luger; cases sometimes fall mouth first into the tube gumming up the works. After looking at some YouTube videos several years ago, I cut an adapter out of plastic container's lid that worked fairly well, but it did take a bit of fitting to get the holes the right size. I used the mouths of different sized cartridges to cut the holes. The plastic then must be secured to the collator with a screw.
I needed another, so I wondered if anyone had drawn one for a 3D printer. Sure enough, I found the Lee Loadmaster 9mm case collator modification. I don't have a 3D printer, so I used a printing service(Print A Thing) to print the item. I had two printed and received them in six days. The total cost of the order was $18.50 which include 6.50 for shipping, so $6/ea. You can make some selections with the printing, I used a high resolution to get a very smooth finish, and that added a little to the cost.
Fit like a glove!
Filled both my 32 Auto and 9mm Luger tubes, not one upside down case!
3D Printed Collator Adapter for 9mm Luger
- Ranch Dog
- Site Admin
- Posts: 6458
- Joined: 22 Jun 2013 17:16
- My Press Choice: Progressive
- Location: Inez, TX
- Has thanked: 1617 times
- Been thanked: 2851 times
-
- Posts: 15
- Joined: 30 Jun 2013 09:19
- My Press Choice: Hand Press
- Location: SE KS
- Been thanked: 8 times
Re: 3D Printed Collator Adapter for 9mm Luger
Excellent mod, might have to do the same to mine. Presently I use a center drilled penny held in place with a screw.
- akuser47
- Moderator & Supporter
- Posts: 1397
- Joined: 30 Jun 2013 09:16
- My Press Choice: Single Stage
- Location: ohio
- Has thanked: 666 times
- Been thanked: 266 times
Re: 3D Printed Collator Adapter for 9mm Luger
Cool, I may find a use some other use for parts To be printed.