Xd 9. And Lee 120tc oal question. Also 125-2r round nose

Discussions covering the components and techniques of reloading for your handgun.
Post Reply
saxmann10
Posts: 7
Joined: 21 Jan 2015 14:55
My Press Choice: Turret
Location: United States
Has thanked: 2 times

Xd 9. And Lee 120tc oal question. Also 125-2r round nose

Post by saxmann10 »

Lee 120tc bullet in a xd9.having problem setting oal. Set at 1.095 passes the plunk test on a dummy round. But new to reloading 9mm and worried about pressure.lyman has sim bullet at 1.110. I also coasted some Lee 125-2r round nose to set up next. Any help appreciated .
Steve
Founding Member & Supporter
Founding Member & Supporter
Posts: 1099
Joined: 21 Jan 2014 20:57
My Press Choice: Progressive
Location: Eastern Iowa
Has thanked: 182 times
Been thanked: 357 times

Re: Xd 9. And Lee 120tc oal question. Also 125-2r round nose

Post by Steve »

Are you below the max load listed in the load manual?
saxmann10
Posts: 7
Joined: 21 Jan 2015 14:55
My Press Choice: Turret
Location: United States
Has thanked: 2 times

Re: Xd 9. And Lee 120tc oal question. Also 125-2r round nose

Post by saxmann10 »

Just working some dummy rounds. But will start at low end. I have titegroup ,universal ,wsf,700x and a lot of csb-1(using universal data)been happy with the csb1 universal is kind of dirty burning .
On the 120tc---- 1.107 oal hits the rifling in barrel, 1.095 . Passes the plunk test, but just covers the top of lube groove. Could go deeper to just below the drive band but concerned about pressure problems.
I have no problems with 45acp and developed a accurate round for 200swc and 230tc
Post Reply

Return to “Handgun Reloading”