Powder coating question

Using your home cast bullets as a ammunition component. Group buys are listed here.
larryw
Founding Member & Supporter
Founding Member & Supporter
Posts: 1123
Joined: 20 Dec 2013 11:09
My Press Choice: Single Stage
Location: Arizona
Location: Arizona
Has thanked: 688 times
Been thanked: 327 times

Re: Powder coating question

Post by larryw »

GasGuzzler wrote:There is some good information on YouTube and the internet.
I also agree with this 100%...
I see what you ment now, there IS some good info.
It is never the less, a frightening thing to know for sure, through
personal experience that there are some out in Webworld, unfortunately
the ones I know are new, or relatively new loaders & again
unfortunately even after a an almost fatal, but still life & limb altering
accident these folks still operate on the misguided belief that
"it's on the web, so it's real" I know, I know, "you can't fix stuid"
But it sure can almost be killed & for sure maimed.
One of these people was / is my nephew, took some 44 Mag load,
off the web, decided it was gospel & would be his hot, nuclear
load??? Problem was, it was nuclear all right, it was some sort of rifle powder from some foreign military surplus??? He now has a 2 digit claw where a perfectly good right hand used to be & took 5 or 6 operations to keep somewhat good use of his left. It's a crying shame stupid can't be fixed but when stupid can't even be recognised when seen, like on
the web, well, that's down right frightening!!!!!!
A day late & A dollar short? Story of my life +guns
larryw
Founding Member & Supporter
Founding Member & Supporter
Posts: 1123
Joined: 20 Dec 2013 11:09
My Press Choice: Single Stage
Location: Arizona
Location: Arizona
Has thanked: 688 times
Been thanked: 327 times

Re: Powder coating question

Post by larryw »

Sorry 'ya all, sorry Michael.
Now, for your musical enjoyment, back to the original
topic of, Powder Coating.
A day late & A dollar short? Story of my life +guns
User avatar
RBHarter
Founding Member
Founding Member
Posts: 2040
Joined: 13 Mar 2014 19:45
My Press Choice: Single Stage
Location: The green hell 90 miles north of Texarka
Has thanked: 76 times
Been thanked: 669 times

Re: Powder coating question

Post by RBHarter »

There is a thread on Castboolits dedicated to HyTek . I was interested in PC for a while , I read all 2800 posts at that time . Last time I check in it was over 4800 posts probably closing on 6k by now .

Outside of gas guns I can't see a good reason for me to change and my skill set and good fortune in moulds is making that successful enough that isn't an issue .
Just a Red neck,White boy, Blue blood American.....
Post Reply

Return to “Cast Bullets, Buckshot, & Slugs”