Switch to full style
Topics concerning individual handgun & rifle bullet designs, buckshot, and shotgun slugs.
Post a reply

25 acp mold that is not $5 Million dollars

29 Mar 2019 21

Can anyone tell me where i can find a 25 acp mold and not pay an arm and a leg for it i like to have at least 1 mold for each caliber i reload not that i do a ton of 25 acp reloading i just don't want to pay high prices for a mold i wont use that often.

Re: 25 acp mold that is not $5 Million dollars

30 Mar 2019 08

Try powder coating a #3 buckshot. or you may be able to force a #1 buck through a .253 sizing die. Or get a lee 2 cavity mold blank and drill and polish a .254 hole.

Re: 25 acp mold that is not $5 Million dollars

30 Mar 2019 09

Short of finding a used mould I think this is probably about as cheap as it's going to get . $79-99 2-5 cavities . New Lyman singles are $70-80 and double RCBS moulds start at $80 . Arsenal might do one . Redding and Hoch are likely to start at $100 and then get expensive .

http://noebulletmolds.com/NV/index.php?cPath=554_555

Re: 25 acp mold that is not $5 Million dollars

30 Mar 2019 15

Ahh, another 25 Auto reloader!

Heck, I'd sell you my mold for a $1M, just could not go lower.

Be sure you slug your barrel, these little buggers can vary.

Re: 25 acp mold that is not $5 Million dollars

31 Mar 2019 19

I just let one go.. a lee 6 banger.. can’t remember the number... but I will tell you The 25 auto was the most frustrating cal I ever did... I know that some have figured it out, but it was wayyyyy above my pay grade. 22 cal is way easier for me with cast.. glad to see it go... it reminded me of my many many failures with that thing.

Re: 25 acp mold that is not $5 Million dollars

02 Apr 2019 08

Danny, I poked around, and I have two special order Lee six cavity molds that I would sell.

One is a TL256-50-RF which has tangent ogive for fat chambers. The other is a TL255-50-RF with a secant ogive, can be sized down to .252”.

PM me if you are interested in price and drawings.

Re: 25 acp mold that is not $5 Million dollars

02 Apr 2019 13

thanks Ranch Dog but after alot of research, thought and advice from more of the seasoned re-loaders aka "the wonderful old farts of this forum" i have decided to forget about casting for now of 25 acp.

Re: 25 acp mold that is not $5 Million dollars

03 Apr 2019 05

Dannymcmullen wrote:thanks Ranch Dog but after alot of research, thought and advice from more of the seasoned re-loaders aka "the wonderful old farts of this forum" i have decided to forget about casting for now of 25 acp.

That's too bad, a cast bullet is a wonderful thing in the 25 Auto.

Image

I use the Load-Master.

Image

Re: 25 acp mold that is not $5 Million dollars

23 Apr 2019 12

Get a group buy together and order a custom run from Lee. They already have the design, as they used to sell a .25 ACP mold.

https://leeprecision.com/custom-service ... let-molds/
Double cavity molds are $26.00 (min. 2 mold order required) and six cavity molds are $54.00, plus Shipping/Handling.
The setup and tooling fee will be waived on orders of 40 pieces or more.
Post a reply