Lee Pro 10lb pot assembly

Precision Melter, Magnum Melter, Production Pot IV, and Pro 4-20
Post Reply
User avatar
GFKIRKLAND
Posts: 27
Joined: 13 Jan 2019 12:43
My Press Choice: Single Stage
Location: Ayr
Has thanked: 8 times
Been thanked: 6 times

Lee Pro 10lb pot assembly

Post by GFKIRKLAND »

Hi Lee Loaders,

I have recently purchased a new Lee Heating Coil for my Lee Production Pro IV (bottom pouring pot) as my original coil had burnt out, due to dampness in garage. When trying to rebuild it, the melting pot is sitting very high, a good inch or so from the top of the coil assembly I was wonder if anyone had seen this before and if there were any suggestions. :? :? :cry:

Regards
Gavin

From Ayrshire in South West Scotland.
User avatar
Macd
Supporter
Supporter
Posts: 1009
Joined: 16 Oct 2017 16:12
My Press Choice: Single Stage
Location: Far East
Has thanked: 362 times
Been thanked: 403 times

Re: Lee Pro 10lb pot assembly

Post by Macd »

Picture would help.
Post Reply

Return to “Melters & Furnaces”