Page 1 of 1
case trimer "stud"
Posted: 08 Nov 2018 10:39
by Ohio3Wheels
I have 4 of these including one that came in a set of 6 of the of the shell holders. One of them has a hole in it that the pin on the gauge drops into the others are blank no hole. What is the one with the hole for?
One more - are there two different diameter cutters?
Make smoke,
Re: case trimer "stud"
Posted: 08 Nov 2018 11:30
by horseman
Ohio3Wheels wrote:I have 4 of these including one that came in a set of 6 of the of the shell holders. One of them has a hole in it that the pin on the gauge drops into the others are blank no hole. What is the one with the hole for?
One more - are there two different diameter cutters?
Make smoke,
Pictures??? Not sure which parts you're talking about.
Re: case trimer "stud"
Posted: 08 Nov 2018 13:09
by daboone
The one on the right is the Lock Stud. I've been using these for over 10 or 15 year. Never saw one the came with a set of 6 shellholder. As I recall there used to be a round shaft on the lock stud. The shell holders did come in a box the held 12.
Re: case trimer "stud"
Posted: 08 Nov 2018 14:57
by Ohio3Wheels
daboone wrote:The one on the right is the Lock Stud. I've been using these for over 10 or 15 year. Never saw one the came with a set of 6 shellholder. As I recall there used to be a round shaft on the lock stud. The shell holders did come in a box the held 12.
The set of 6 dates back to the Lee Custom Engineering days.
Make smoke,
Re: case trimer "stud"
Posted: 09 Nov 2018 09:54
by Ranch Dog
Here you go...
Re: case trimer "stud"
Posted: 09 Nov 2018 11:33
by horseman
Oh, okay. I've got a couple of the ones Dan shows along with the one with the ball handle. Never have seen the ones that Ranch Dog shows. I would "assume" the one in Dan's post is a newer model. Works just fine with a hand drill or power screwdriver (along with Dan's beloved three jaw chuck
). I also use some of this system (three jaw chuck
) for turning necks on rifle cases.