Page 1 of 1

My Loading bench and set up

PostPosted: 13 Sep 2020 16
by Damin69
So this is my set up. I have a LEE APP, Lee Classic Turret and a Lee Load Master. I built a raised platform to get my press up so when using my press I was not bending over all the time as it would really put a crick in the neck. I put all my presses on Lee Bench Plate system for quick changes between presses since I only dedicated about 8 foot of my shop work bench to Reloading this keeps the space required down. I primarily reload 9mm and 223 but I will be reloading 380 auto, 30-06, 45 ACP and probably some 32 WS Special. I have a Metal Locker in my Shop that I keep all my Presses and Cleaned brass in when I am not reloading. For case prep I have sonic cleaner but what really works best is Wet tumble in Southern Shine steel Media. Chase trimming I use a Hornady Trimer with the RCBS 3-way cutter head.
I just recently added a Oiiwak Borescope Inspection Camera on my bench for helping verify powder charge and as you can see it does a super job worth every penny. I was using a Wyze cam it did well but this works way better.

Image
Image
Image
Image
Image

Re: My Loading bench and set up

PostPosted: 14 Sep 2020 07
by AlaskanGuy
wow.... looks very organized and the camera is awesome... very clean and neat too... far cry from my mess... he he

Re: My Loading bench and set up

PostPosted: 13 Oct 2020 16
by Shooterrick2020
Great looking setup appreciate the input