Infrared primer detection on Loadmaster
Posted: 22 Sep 2020 21:39
IR sensor board Configured for primer detector
The object here is to notify operator if there is not a primer in the shell when its time to add powder to the shell. It will light a led which probably wont be seen, it will also beep for an audible notice.
Parts list: From Amazon, or suitable parts. Amazon comes in 5 packs for parts, but they are cheap. Build them for your friends, or find other purposes.
* Cylewet SFM-27 DC 3-24V Electronic Buzzer Alarm Sounder Continuous Sound Beep CYT1083.
* DAOKI IR Infrared Obstacle Avoidance Sensor Module for Arduino Smart Car Robot 3-wire.
* LeMotech ABS Plastic Electrical Project Case Power Junction Box, Project Box Black 2.83 x 1.65 x 0.91 inch (72x 42x 23 mm). Box cant exceed 1.7” height to go where I put it.
* 5 volt USB power supply.
* USB cable to remove end to use for power cord.
* Silicone rubber or similar to mount the relocated LED inside the press under the shell plate for the powder station, I used it also to mount the buzzer on the case.
* I used 22 ga 2 conductor wire or similar
BOARD SPECIFICATION
* The output port OUT sensor module can be directly connected to the microcontroller IO port , you can directly drive a 5V relay ;
* the module detects the distance 2 ~ 30cm, detection angle 35°, the distance can detect potential is adjusted (angle is not that wide, thought I read 7°)
* Can be used for 3-5V DC power supply modules
* When the power is turned on, the power indicator light
* Using the comparator LM393. Output is open collector.
* Interface :
* 1. VCC: External 3.3V-5V voltage (can be directly connected to 5v MCU and 3.3v MCU)
* 2. GND: GND External
* 3. OUT: Small board digital output interfaces (0 and 1)
* Connection : VCC-VCC; GND-GND; OUT-IO
* With the screw holes of 3mm , easy fixed installation
* Board Size : 3.1CM * 1.5CM / 1.22 * 0.59″
Wiring the device:
* To VCC: Red wire from the USB cable, red wire from the buzzer.
* To OUT: Black wire on buzzer.
* To GND: Black wire from the USB cable, shield wire from the USB cable. Any other wires from the USB cable can be cut off.
* You need to relocate the Clear LED. Remove the LED from the circuit board, and add a extension wire to it. Install it inside the press underneath the station 3 primer hole so it can see through the primer hole in the shell. Once it is installed, resolder the wire to the circuit board using the same polarity it was mounted with.
Mount the board inside the box paying attention so the led exits the box located in the center of the powder dispensing hole above the LED firing up from the shell plate. My measurements were .12” from the rear of the box.
Page for data on the module https://osoyoo.com/2018/12/21/arduino-l ... ce-module/ has the schematic and all.
The angle on the sensors is tight, but it is easy to align. I put a shell with no primer in the bottom of the expander die and shine the led up through the die into the sensor in the module. Use a dab of silicone rubber to mount the led just to get it held down, then once verified and cured, mount it better. You should be able to run the ram the full length of the press with detection working.
Any questions, just ask.