Micro Disk

[62chevy]

What can I say but that it works just fine. Wanted 2.4 grains of TiteGroup and ended up with 2.5 with the 24 cc hole. Stayed consistent at 2.5 too with only 2 out of 10 coming in at 2.4.

[Ranch Dog]

What can I say but that it works just fine. Wanted 2.4 grains of TiteGroup and ended up with 2.5 with the 24 cc hole. Stayed consistent at 2.5 too with only 2 out of 10 coming in at 2.4.

Did you determine a VMD for your lot of powder for this work or did you use the standard .0885?

Titan has a lot of good ideas no doubt; they have press covers, a Powder Baffle and a neat Lock Nut Wrench! They dropped the Micro Disk so they must have had problems with the product or there was no demand.

[62chevy]

I used the one from Lee and worked my way around. I wanted 2.4 grains and doing the math said I need the 21 cc but that only dropped 2.2 or 2.3 grains so went to the 24 cc and got 2.5 grains. I'm using the Lee TL-356-95-RF and that drops at 97 or 98 grains so the best I can figure is 2.4 to 3 grains of TiteGroup. Last fall I test 2.4, 2.5, 2.6, 2.7 and 2.8 but 2.7 and 2.8 seemed a bit heavy and 2.4 worked just fine and felt good. None showed any sign of flat primers.

[62chevy]

RD the micro disk can be found here, 4 left as of today.

http://www.titanreloading.com/powder-ha ... cro-charge

[Ranch Dog]

RD the micro disk can be found here, 4 left as of today.

http://www.titanreloading.com/powder-ha ... cro-charge

That's good! I looked this morning including using their website search and could not find them.

[62chevy]

RD the micro disk can be found here, 4 left as of today.

http://www.titanreloading.com/powder-ha ... cro-charge

That's good! I looked this morning including using their website search and could not find them.

LOL I think we all have had that problem at one time.