But not too slick. I've seen that cause problems on a friends LoadMaster.Steve wrote:The area the case slides on must be clean.
Switching LoadMaster from 38SPL to 9mm Luger
- buckeye43210
- 250 Shots
- Posts: 253
- Joined: 20 Dec 2014 09:47
- My Press Choice: Progressive
- Location: TPA
- Has thanked: 23 times
- Been thanked: 131 times
Re: Switching LoadMaster from 38SPL to 9mm Luger
Last edited by buckeye43210 on 10 Aug 2016 13:56, edited 1 time in total.
-
- Posts: 156
- Joined: 12 Apr 2016 13:13
- My Press Choice: Progressive
- Location: SE Michigan
- Has thanked: 32 times
- Been thanked: 38 times
Re: Switching LoadMaster from 38SPL to 9mm Luger
Fully agreed. When the next 38 case is being dragged from under the stack of cases in the tube, the next case up in the tube is sitting on top of it. The slide causes the case to tilt against the movement and since I was using the small slide, the section of the slide moving the case is less then half of the height of the case - the laws of physics say that the case will tilt. And so it did.
Using the large slide the issue is eliminated as the slide pushed on about 3/4 of the case height so it will not tilt over.
Using the large slide the issue is eliminated as the slide pushed on about 3/4 of the case height so it will not tilt over.